Aplex-technology ARCDIS-108 Manuel d'utilisateur télécharger pdf (Page 54)

ARCDIS-1XX (TB-6028) User Manual

Appendix B: Panel Mounting and VESA Mounting

The ARCDIS-1XX is designed to be panel-mounted and VESA mounted as shown in

Picture. Just carefully place the unit through the hole and tighten the given screws

from the rear to secure the mounting.

Figure B: Panel mounting and VESA mounting

*Notice：

Tighten the mounting clip screws by hand until the gasket seal contacts

the mounting surface uniformly.

Tighten the mounting clips screws to a torque of 8 ~ 10 kgf-cm by using

the specified sequence, making sure not to overtighten.

*Tighten the mounting clips to the specified torque to provide a proper

seal and to prevent damage to the product. Aplex assumes no

responsibility for water or chemical damage to the product or other

equipment within the enclosure due to improper installation.

1 2 ... 49 50 51 52 53 54

Pas de commentaire

Aplex-technology ARCDIS-108 Manuel d'utilisateur Page 54